stdlib.h

Go to the documentation of this file.

/*
 * Copyright (c) 2020 Raspberry Pi (Trading) Ltd.
 *
 * SPDX-License-Identifier: BSD-3-Clause
 */
 
#ifndef _PICO_STDLIB_H
#define _PICO_STDLIB_H
 
#include "pico.h"
#include "pico/stdio.h"
#include "pico/time.h"
#include "hardware/gpio.h"
#include "hardware/uart.h"
 
#ifdef __cplusplus
extern "C" {
#endif

 
// Note PICO_STDIO_UART, PICO_STDIO_USB, PICO_STDIO_SEMIHOSTING are set by the
// respective INTERFACE libraries, so these defines are set if the library
// is included for the target executable
 
#if LIB_PICO_STDIO_UART
#include "pico/stdio_uart.h"
#endif
 
#if LIB_PICO_STDIO_USB
#include "pico/stdio_usb.h"
#endif
 
#if LIB_PICO_STDIO_SEMIHOSTING
#include "pico/stdio_semihosting.h"
#endif
 
// PICO_CONFIG: PICO_DEFAULT_LED_PIN, Optionally define a pin that drives a regular LED on the board, default=Usually provided via board header, type=int, min=0, max=47 on RP2350B, 29 otherwise, group=pico_stdlib
 
// PICO_CONFIG: PICO_DEFAULT_LED_PIN_INVERTED, 1 if LED is inverted or 0 if not, type=int, default=0, group=pico_stdlib
#ifndef PICO_DEFAULT_LED_PIN_INVERTED
#define PICO_DEFAULT_LED_PIN_INVERTED 0
#endif
 
// PICO_CONFIG: PICO_DEFAULT_WS2812_PIN, Optionally define a pin that controls data to a WS2812 compatible LED on the board, type=int, min=0, max=47 on RP2350B, 29 otherwise, group=pico_stdlib
// PICO_CONFIG: PICO_DEFAULT_WS2812_POWER_PIN, Optionally define a pin that controls power to a WS2812 compatible LED on the board, type=int, min=0, max=47 on RP2350B, 29 otherwise, group=pico_stdlib

void setup_default_uart(void);
 
#ifdef __cplusplus
}
#endif
#endif